A crown disk may, however, be
melted a number of times without serious injury. In many cases--
perhaps the majority--the artisan finds that after all his months
of labor he cannot perfectly clear his glass of the noxious veins,
and he has to break it up into smaller pieces. When he finally
succeeds, the disk has the form of a thin grindstone two feet or
upward in diameter, according to the size of the telescope to be
made, and from two to three inches in thickness. The glass is then
ready for the optician.
[Illustration with caption: THE OPTICIAN'S TOOL.]
The first process to be performed by the optician is to grind the
glass into the shape of a lens with perfectly spherical surfaces.
The convex surface must be ground in a saucer-shaped tool of
corresponding form. It is impossible to make a tool perfectly
spherical in the first place, but success may be secured on the
geometrical principle that two surfaces cannot fit each other in
all positions unless both are perfectly spherical. The tool of the
optician is a very simple affair, being nothing more than a plate
of iron somewhat larger, perhaps a fourth, than the lens to be
ground to the corresponding curvature. In order to insure its
changing to fit the glass, it is covered on the interior with a
coating of pitch from an eighth to a quarter of an inch thick.
Pages:
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126